The main and upper floors as the architect drew them, and the same two plans with every piece of equipment this manual can actually put a pin in.
956 N Noble Loop · Showing Edition · Rev A · Aug 2026
Every “Where” line in this manual points at one of these two drawings. They are traced by hand from the architect’s 1/4″ = 1′-0″ sheets for this house, and every dimension printed on them is the sheet’s own — nothing here was measured or estimated on site.
The plans are drawn street-side down: the garage overhead door and the front door are on the bottom edge, the covered patio and the rear yard on the top. The architect’s sheets carry no north arrow, but the house does — the front faces west — so every drawing in this manual converts to the compass the same way:
On the drawing
On the ground
What is there
Bottom edge (down)
West
The street. Garage overhead door, front door, driveway.
Top edge (up)
East
The covered patio, the rear lawn and the raised beds.
Left edge
North
The garage’s utility wall — man door, electrical service — and the exterior equipment wall outside it.
Right edge
South
The kitchen, dining room and den side of the house.
Reading the plan while standing in the house
Stand at the front door looking in and you are facing east, which is up the page. Turn the sheet so the street is at the bottom and everything lines up: your left hand is north, your right hand is south. Every “Where” line in this manual is written in compass directions, so it reads the same way whether you are holding the binder or standing in the room.
The plans
Main floor — patio and family room across the east (rear), kitchen and pantry, dining, entry and den on the west (street) side, and the L-shaped garage along the north half, whose deep back bay is the mechanical room.
Upper floor — the master suite along the north side, its bedroom in the northeast corner and the steam shower deeper in, three more bedrooms/offices, the hall bath, the furnace closet, laundry, and the bonus/media room at the west (street) end.
Everything the manual can place
The same two plans, with a pin on every piece of equipment the registry can locate. Each system page shows its own single-pin version of this map in its At-a-Glance panel; this is all of them at once.
Main floor — every located fixture and piece of equipment.
Upper floor — every located fixture and piece of equipment.
How exact the pins are
Most places on these plans sit where the architect’s sheet puts them, to the inch. A handful are placed to the nearest sensible spot instead — the bonus/media room, the bedroom-3 closet that holds the network gear and the steam generator, and the exact wall an item hangs on inside the garage back bay. Today 5 of the registry’s places carry that mark, and each is a walkthrough item.
What is deliberately not on these plans
Some equipment is real, photographed, and still unplaced — the main electrical service and meter, the two Powerwalls and the PV inverters on their exterior equipment wall (the north wall, immediately outside the garage’s electrical panel), the outdoor AC condenser, the ecobee thermostat, the projector and screen inside the media room, and the main water shutoff. Rather than guess at geometry, this manual leaves them off the drawing; each is a walkthrough item, and the main water shutoff is the most important of them.
Two other maps stay off this page on purpose: the network drop map (see Network & Connectivity) and the camera coverage map (see Security & Access). Both are owner’s-edition material, not showing material.